LED Blink Demo

This program is simple demonstration of the LEDs

Hardware required:

• SLMX4-HW
• epam-x4 (or other pin-compatible x4 module)

This program uses the Red, Green, and RGB LED in a few modes. Under the “Modes” section below, uncomment one mode and comment out all the others. Some modes can be mixed though.

Modes:

• BLINK_RED_LED
  This mode blinks the Red LED at a fixed rate
• BLINK_GREEN_LED
  This mode blinks the Green LED at a fixed rate
• BLINK_RGB_LED
  This blinks the RGB LED at a fixed rate. This essentially is setting the RGB LED to either the current color or “off”
• COLOR_CYCLE_RGB_LED
  This mode cycles the RGB LED through the HSV color space by manipulating the hue value
• THROB_RGB_LED
  This mode color cycles the RGB LED by manipulating the hue as in the color cycle mode. However, this mode also manipulates the value in the HSV color space, which changes the brightness
• NIGHT_THROB_LED
  This mode throbs the brightness for night time use in a heartbeat pattern